HX3 KeyB Duo Installation
Aus KeyboardPartner Wiki
Zur Navigation springenZur Suche springen
This page shows installation of an HX3 mainboard (FPGA based) as a replacement for KeyB Duo sound generator (DSP based). Board is completely remoted by MIDI from KeyB controller. All knob/button/drawbar functions are retained. Installation is quite simple, but requires soldering skills and crimping flat ribbon cables. Click pictures to enlarge.
To prevent KeyB to send MIDI data before HX3 is ready to accept, the KeyB Duo controller RESET must be delayed. This is done by using a signal on wire 8 of HX3 PL17. Solder single wire #8 from ribbon cable to R10 on KeyB controller board as shown. Use R10 pin pointing to U1. Cut off all other wires of PL17 cable.
Replacing the KeyB key scan is optional. Installing a FatarScan2 board for direct connection to HX3 yields much lower key latency.
Remove lower KeyB keybed and install FatarScan2 board with plastic spacers, using M3 screws. Some holes must be drilled in base plate. Route 10-wire ribbon cable from HX3 PL14 to FatarScan board. Disconnect Fatar keybed cables from KeyB MIDI controller and install 16-pin flat ribbon connectors, pin 1 pointing to coloured wire.