Installation XB2-Kit

Installation in Hammond XB-2

(This page in english for int'l customers)

Installation in Hammond XB-2 may be performed by any skilled person; no or very little soldering required. Please click on picture to enlarge.

Open XB-2 by loosening 5 big screws on bottom. Remove keyboard by loosening 7 medium sized black screws on bottom and inside organ. Diconnect keyboard from mainboard plug connector. DO NOT cut any cables, just unplug all connectors!

Remove all boards inside including supporting rails. Retain cables from power supply and volume/reverb pots. Locate pink/black/green/orange strain and separate black/white strain to now unused connectors. Cut as pictured and insulate with shrink tube. DO NOT cut long orange/black/green/black/yellow cable!

Install HX3 mainboard and LCD interface board as pictured using wood screws and 5mm plastic spacers. Cut and Connect black/yellow strain to green HX3 power connector (plus = yellow, Gnd = black). Connect LCD and button cables to matching connectors on LCD interface board.

Install jack board from XB-2 kit and connect 5-pin power connector from power supply (orange/black/green/black/yellow), also connectors from volume/reverb pots.

Install five 10-pin and one 16-pin flat ribbon cables from LCD interface board to HX3 board as pictured.

Install long 10-pin flat ribbon cable from HX3 PL12 to jack board and long 8-pin flat ribbon cable from LCD interface board to jack board.

Install two 3-pin audio cables from HX3 to jack board according to silk screen lettering. Re-install MIDI jack board and connect to 12-pin MIDI bulk connector. Install 2-pin contrast adjust cable from small MIDI adapter board to LCD interface board.