HX3 MenuPanel: Unterschied zwischen den Versionen
Aus KeyboardPartner Wiki
Zur Navigation springenZur Suche springen
Bovist (Diskussion | Beiträge) KKeine Bearbeitungszusammenfassung |
Bovist (Diskussion | Beiträge) KKeine Bearbeitungszusammenfassung |
||
| Zeile 1: | Zeile 1: | ||
[[Datei:MenuPanel_full.JPG| | [[Datei:MenuPanel_full.JPG|400px|thumb|right|HX3 MenuPanel]] | ||
== Installation == | == Installation == | ||
Version vom 11. Dezember 2013, 20:24 Uhr
Installation
Just connect the MenuPanel to HX3 PL4 using a 10-wire flat ribbon cable. Only connect/disconnect when power is off. HX3 firmware from version 3.41 and up will recognize the MenuPanel and act accordingly.
MenuPanel may be used in parallel with Preset12, Preset16 and Preset24 boards connected to HX3 PL4. Extend a flat ribbon with additional connector to your cable on HX3 PL4 or use unoccupied 10-pin header on (last) Preset16 board which also carries the PL4 signal.
For menu system usage, see HX3 MIDI expander module page.
