Installation in Hammond XB-2 (old HX3 kit): Unterschied zwischen den Versionen
Aus KeyboardPartner Wiki
Zur Navigation springenZur Suche springen
Bovist (Diskussion | Beiträge) K (Die Seite wurde neu angelegt: „== Installation in Hammond XB-2 (old HX3 kit) == '''Obsolete, for reference only!''' [[Datei:Xb2_04.JPG|640px|thumb|left|'''Install HX3 mainboard and LCD interf…“) |
Bovist (Diskussion | Beiträge) |
||
(Eine dazwischenliegende Version desselben Benutzers wird nicht angezeigt) | |||
Zeile 2: | Zeile 2: | ||
'''Obsolete, for reference only!''' | '''Obsolete, for reference only!''' | ||
Installation in Hammond XB-2 may be performed by any skilled person; no or very little soldering required. Please click on picture to enlarge. Please also regard Wiki HX-3 user manual on [[Bedienungshinweise#XB2-Nachrüstsatz]]. | |||
Note: This kit is no longer produced, use for reference only! For new HX3/XB-2 kit with much simpler installation, see '''[[Installation XB2-Kit]]'''. | |||
[[Datei:Xb2_01.JPG|640px|thumb|left|'''Open XB-2 by loosening 5 big screws on bottom. Remove keyboard by loosening 7 medium sized black screws on bottom and inside organ. Diconnect keyboard from mainboard plug connector. Remove nylon wire straps, but DO NOT cut any cables, just unplug all connectors!''']] | |||
[[Datei:Xb2_02.JPG|640px|thumb|left|'''Remove all boards inside including supporting rails. Retain cables and headers from power supply, front panel, drawbars, LCD and volume/reverb pots. Locate pink/black/green/orange strain and separate black/white strain to now unused connectors. Obsolete XB-2 power connectors may be cut off as pictured or may be left open. Insulate cut wires with shrink tube. DO NOT cut long orange/black/green/black/yellow cable!''']] | |||
[[Datei:Xb2_04.JPG|640px|thumb|left|'''Install HX3 mainboard and LCD interface board as pictured using wood screws and 5mm plastic spacers. Cut and Connect black/yellow strain to green HX3 power connector (plus = yellow, Gnd = black). Connect LCD and button cables to matching connectors on LCD interface board.''']] | [[Datei:Xb2_04.JPG|640px|thumb|left|'''Install HX3 mainboard and LCD interface board as pictured using wood screws and 5mm plastic spacers. Cut and Connect black/yellow strain to green HX3 power connector (plus = yellow, Gnd = black). Connect LCD and button cables to matching connectors on LCD interface board.''']] |
Aktuelle Version vom 28. September 2013, 09:35 Uhr
Installation in Hammond XB-2 (old HX3 kit)
Obsolete, for reference only!
Installation in Hammond XB-2 may be performed by any skilled person; no or very little soldering required. Please click on picture to enlarge. Please also regard Wiki HX-3 user manual on Bedienungshinweise#XB2-Nachrüstsatz.
Note: This kit is no longer produced, use for reference only! For new HX3/XB-2 kit with much simpler installation, see Installation XB2-Kit.